Weigh-In-Motion Strip Sensors

$0.00

Strain Gauge Load Cell Sensors in a Minimally Invasive Enclosure for Quick Installation
Weigh Vehicles at Speeds up to 80 mph (130 km/h)
Designed to Comply with COST 323 & ASTM E1318-09
Used in Screening, Enforcement, Data Collection, Tolling & Ports WIM Applications
Use to Address SOLAS Verified Gross Mass Container Requirements

Download product PDF
Category:

Features

Intercomp?s strain gauge based Strip Sensors are a unique alternative to traditional sensor based technology yet a more accurate and longer lasting alternative for ASTM E1318-09 Type I, Type II, Type III and COST 323 A(5), B+(7) or B(10) requirements for High Volume Data Collection and Screening for Direct Enforcement. Installed within grooves less than 3″ (75 mm) in the pavement, the strip load cell delivers lower cost because of the minimal time & labor associated with installation and maintenance.
Contact us for more information!

Specifications

Typical Configurations


Strip sensors for data collection incorporate strain gauge sensor technology:

  • WIM site installation employs two sensors, loop, and electronics
  • Provides Accurate Data for Roadway Monitoring & Planning
  • Detection of Overloaded Vehicles & Incidence
  • Integrate Sensors in Existing Pavement or during Site Replacement
  • Stable readings with environmental fluctuations of temperature
  • Minimally invasive in-ground installation
  • Does not require frames or drainage
  • Maintenance free operation
  • Integrate with variety of electronics

Product categories